Welcome
FEATURED ARTICLE:
Keep Your Gas Chainsaw Running Smoothly
Do you own a gasoline powered chainsaw? You will need to keep it in good operating condition. You can take certain steps to make sure that your saw works well. This may help you to avoid injury or unsafe conditions. Here are some chainsaw tips to consider.
Make sure that you are using the correct fuel ratio. If it is too rich, it can run bad and foul your spark plug. It may also make your carburetor dirty. If the mixture is too lean, your engine will not get enough oil. Some products like Husqvarna chainsaws, come with their own premixed bottles of oil. This makes it impossible to mix the wrong fuel ratio.
Your chain is one of the most important items on your saw. Check it before every use. Normal use will cause your chain to wear and eventually dull. You should adjust the tension, whenever needed. If the blade is dull, have it sharpened. When adjusting the chain, you may need to check with the operating manual. Not all chain-adjusting methods are the same.
The chain bar needs to be inspected regularly. You should rotate it about every ten hours of running time. When your saw runs, the chain will wear more at the bottom of the chain bar. When you rotate the bar, it changes the top and bottom positions. Be sure that you clean the bar before each use.
Your chain oil system is vital to the saw. It must be working properly at all times. You may need to take off chain covers and examine everything before each use. Clean all wood material and debris from the saw. This is very important. Too much debris inside can knock the chain from the track. It can also stop up your oil system. This is the only way that your blade can get lubrication. It can wear out prematurely if your oil system does not work properly. Check to make sure all oiling holes are clear. After you have cleaned the blade, bar and chain, make sure that your work area is clear.
You may be working inside. Wood debris will have oil in it. This can make it slippery and a safety hazard. Usually a shop vacuum will be the best tool. You may use something like a Dyson upright vacuum cleaner, for example. However, shop vacuums will handle the job easier.
There is another thing to check before operating. Are all of the screws and bolts tight? Saws vibrate when running. It will loosen some things, in time.
Be certain that your air filter is not dirty. If it is, change or clean it. Some models like the Poulan chainsaw, may have different types of filters, than others. You may need to check the manual.
Conclusion
Gasoline powered chainsaws are very powerful outdoor tools. You must keep them running smoothly with regular maintenance. It will also keep you safe from harm.